Check this oot, are these connectors standard? One of them is leaking and needs a bit of tlc 
Going to get a better look tomorrow and check for any more problem areas.
Going to get a better look tomorrow and check for any more problem areas.
-
-
They look like push lock fittings, we use them on air line at work. They are designed for soft tubing such as plastic tubing (Festo tube) which is still good for 8 bar operating pressure, but not designed to seal on metal, even though the other 2 are sealed.
To pull it apart push the collar and pipe in, then while holding the collar in pull the pipe out. Clean the pipe ends with some wet n dry then re-assemble it.
We have nice stainless steel chromed ones at work which look the dogs danglies---gives me a few idea'sEverything should be made as simple as possible, but not simpler.--:Albert Einstein -
whoever put qr air fittings onto fuel pipe should be shot
Yes they are air fittings, i don't think the plastic lasts that long encased in petrol though so I'd get 'em swapped for some wade connecters asap - see my how to guide on swapping fuel lines...sigpicComment
-
Yea checked out you thread on pipe replacement
Going to get some fittings and change them out asap, didint think they OEM
cheers
SteveComment
Comment