Thread size of S2 turbo nipple

[s2_bo]

I need to know the thread size for the nipple that connects a pipe from the turbo to the WGFV.

Any one know this?

Thanks.

[Jamo]

Normally it is 1/8 NPT which is a tapered thread so it seals

[Jon441cc]

shpot! on

[s2_bo]

Cheers guys.

[twoqu]

What turbo?
Just checked an RS2 one and its an ordinary 10X1.0mm thread!

[Jamo]

That's why I said normally

Stock turbo and aftermarkets use the 1/8 NPT

[twoqu]

Well it looks like 034 145 779D joint pipe is common to all KKK24 variant turbos on the 20VT!
So if its M10X1.0 on the RS2 its the same on the stock K24.

[s2_bo]

I thought RS2 and S2 had the same?

I need the size for an rs2 one as thats what i have on my car. Im replacing all the WGFV hoses with braided vac lines and AN fittings.

Thanks for the info guys!

[Jamo]

Take off your existing one and check best way mate

[twoqu]

Bo!
If you have a clean male brake union you can use that to verify the thread like I have just done!

[s2_bo]

Take off your existing one and check best way mate

I would, but, its cold, wet and dark and i dont have my dremel on charge

Anyway, James is supplying me with the hoses as im a novice when it comes to all these fancy fittings...

[Keeper of The Kitten]

The one out of my K24 is 10x1, definitely not a taper thread ...I've put it in the hybrid with a dowty washer to seal it.

[terrybullwon]

Bo there is a app on the Iphone to find thread sizes and pitch!