Urs4 or Urs6 pas pump and alternator brackets

[quattro]

Could any one enlighten me on the location of the PAS pump and the alternator on the engine of the Origonal s4 or s6, pictures would help......

[Nace20]

perhaps this helps

you can see them behing visco fan

[quattro]

Where dose the belt take drive off, the radiator fan?

[UrS4boy]

Could any one enlighten me on the location of the PAS pump and the alternator on the engine of the Origonal s4 or s6, pictures would help......

Not sure of what you are looking for exactly but I am guessing these will help:

Serpentine Belt Tensioner info:

http://forums.quattroworld.com/s4s6/msgs/22579.phtml

Viscous Fan Bearing Info:

http://forums.quattroworld.com/s4s6/msgs/33332.phtml

If you need more info, let me know.

[quattro]

Have you got actual pictures?

[saltinot]

The black bracket in this picture holds the hydraulic pump. The alternator mounts just below the pump.



The alternator can be seen hanging on the far right side of the engine in this picture. Just above the alternator you can see the "U" where the hydraulic pump sits.



Cheers,

[quattro]

Fantastic, thanks for that.

What a beautifully clean engine btw!

[saltinot]

Thanks....it is the motor I prepared to replace my original one.

If you're interested, the entire thread can be found here.Tom's urS4 motor swap

[PeteUr]

Thanks....it is the motor I prepared to replace my original one.

If you're interested, the entire thread can be found here.Tom's urS4 motor swap

What do you use to clean your engine?

[saltinot]

I started off with a spray on engine degreaser called Stream. It's sold here in the states at auto parts stores. The aluminum I cleaned up in the media blaster using glass beads as my media. I polished a few ally items, like the oil pan and fuel rail, using Mothers Mag Wheel Polish which is basically jewlers rouge. The head was rubbed with 3m General Adhesive Remover with a rag to remove the trouble greasy spots.

It was a lot of scrubbing and rubbing.