I have run into a snag on my engine swap. Does anyone know if there was a steel version of the thermostat housing that would bolt onto an AAN? I need to change the direction that the neck leaves the block.
-
currently: 1987 944 NA 5spd, 250 lb hyper coils, 27 mm t bars, Koni, 968 m030 bars, full delrin, Audi I5 20VT, VEMS, Tilton, EFI Express, Seimens, Race Technologies
see the AAN/944 swap at Nina's 20VT -
Not sure which direction you are needing to go but I think the ABY (very similar to the AAN except with the reverse intake manifold) has a different thermostat housing than the AAN.RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant -
From memory the AAN item is plastic and points towards the back of the car, 7A/3B/ABY item is alloy and points towards the left hand head light.91CQ20v - Gone to a new home
93UR-S4 - The Magic Carpet
94S2Bus - The Emerald ExpressComment
-
Would you have to change the water rail as well though?Comment
-
So then you are saying that the 7a part is made from metal? If that is the case that's just what I need. On my swap I need that water port to travel directly over the water pump mounting location so that it will connect to the lower passenger side of the radiator.currently: 1987 944 NA 5spd, 250 lb hyper coils, 27 mm t bars, Koni, 968 m030 bars, full delrin, Audi I5 20VT, VEMS, Tilton, EFI Express, Seimens, Race Technologies
see the AAN/944 swap at Nina's 20VTComment
-
yup. 7A part will do you fine and its alloy
Panthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 AvantComment
Comment