Where to get various engine bits

[madpugger]

OK guys, looking for a little help here, and hopefully the thread can help others too as it develops.

So for starters I am looking for the following help for my rebuild which is underway again now i have a new crank

2-page version attached with all the KS bearings for S2/RS2.

Paul added this file but the quote lost it ... here
Can someone explain the PL^ PL (down arrow) etc in that link? What part numbers are actually required for atandard size for mains and big end? Which ones are SPUTTER from KS - all of them or just upper big ends and lower mains? Is the thrust bearing seperate with KS?

Most importantly, where to get them and how much are they?

Where can I get an oil pump (ABY) and how much are they likely to be?

Lastly for now, where can we get engine mounts as Audi are now NLA

[topsparky]

i've got an 034 street density engine mount brand new
£40 + postage mate

[madpugger]

i've got an 034 street density engine mount brand new
£40 + postage mate

Thanks

Is is RH or LH or are they the same? I assume it replaces the hydraulic one with Poly or similar? Is the height correct as I seem to remember reading the 034 one was too tall or is this now sorted?

Ta

[topsparky]

Thanks

Is is RH or LH or are they the same? I assume it replaces the hydraulic one with Poly or similar? Is the height correct as I seem to remember reading the 034 one was too tall or is this now sorted?

Ta

mmm not sure on this
part number on bottom is
443 199 379 d weib
443 199 379 e gelb

hope this helps

[madpugger]

mmm not sure on this
part number on bottom is
443 199 379 d weib
443 199 379 e gelb

hope this helps

Cheers, I will get in touch with 034 and get back to you on the two items

[topsparky]

no probs mate

[Error404]

Glad you've got a crank sorted in the end, sorry I couldn't help - blood work

I'm pretty sure the engine mounts are the same part for LHS & RHS

I was trying to understand the KS catalogue a while ago, its a minefield!

[madpugger]

Hmm, my mounts have different part numbers LHS and RHS and the bolt holes are at different spacings. Also Audi list one side as out of production and not the other...

So can anyone give any update on the 034 versions, are they too tall or was that a wrong order?

[Error404]

i think there are issues with a stroker shortblock as its taller, but otherwise no issues AFAIK.
I have 034 engine mounts (cq / 3B type though) they are both the same and have no height issues for me. You will notice the engine sits higher probably as the stock ones are likely to have collapsed.

[madpugger]

OK, Maybe the ABY ADU ones are wrong then, I remeber Bram mentioning that they were around 1cm taller than new stock ones. As I have a reverse IM to go on, I think they are pretty close to the bonnet so that my worry.

[madpugger]

Managed to source OE mounts

Anyone got any info on the KS catalogue?

Thanks