KKK Help needed

[Starscream]

So ive had my Turbo reconditioned and turned into a hybrid, but i havent really got an idea what ive had back to be honest.

I know the ABY's have a K26 right? and mine use to have the oil and water cooling but now it only has the Oil feed.

The reason im asking is that now i have a Tubular manifold the Oil feed lines wont reach, and i need some made up, also the postition of the thread holes are further apart.

Id like to order something similar to these....

http://www.034motorsport.com/turbochargers-and-accessories-turbocharger-accessories-kkk-oil-inlet-flange-kit-p-178.html

And build my own pipes.

Pictures and numbers of turbo to follow

[driftin jo]

So ive had my Turbo reconditioned and turned into a hybrid, but i havent really got an idea what ive had back to be honest.

I know the ABY's have a K26 right? and mine use to have the oil and water cooling but now it only has the Oil feed.

The reason im asking is that now i have a Tubular manifold the Oil feed lines wont reach, and i need some made up, also the postition of the thread holes are further apart.

Id like to order something similar to these....

http://www.034motorsport.com/turbochargers-and-accessories-turbocharger-accessories-kkk-oil-inlet-flange-kit-p-178.html

And build my own pipes.

Pictures and numbers of turbo to follow

All S2 have a k24 not a k26, sounds like you have been given some sort of hybrid using an old k26 centre that only had oil cooling , sounds a bit odd to me.

[Starscream]

The coolside has a 70cm inlet and a 50cm outlet on the coolside.




It also has the numbers - 4 89 53271015070




In this picture there is a 3




Now the hotside, numbers are very difficult to read - and to be honest it looks like lines with the letter A underneath.





Morte Numbers on the hot side - NI81CR3552 - 6 (some sort of logo) 2 - 271(A BIT LARGER FONT) 53261816967 E (the 6's could easily be 8's in this number)




And a No. 6 here, Also the Hotside has a 55cm exhaust outlet to downpipe and a 50cm from the manifold to turbo.

[Starscream]

Openingings for the oil are as follows.

The one that would sit visible from the top when fitted oil feed hole is 9mm, bolt holes are 38mm apart, and for the other side it has a 20mm opening for oil and the studs are 50mm apart.

Will have to have the bits custom made or do 034 supply them and its just past me?

[Error404]

from what I've read the 034 ones are pants and don't fit / leak so you are best off making your own or talking to the like of Speedflow who will make them for you