Heat Shield?

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Lloyd
    replied
    is it possible these are the PN? (from a previous post)

    Heat Shield part numbers:

    There's two, an upper 895 804 161 (sits below turbo on inner wing) and a lower further down which part covers the chassis rail.

    Lower one if needed is 895 804 162.

    Leave a comment:


  • Rusty
    replied
    There are part numbers for the shields for the transmission tunnel and exhaust but nothing that I can find for that - it references a drawing that I can't find

    Leave a comment:


  • Lloyd
    replied
    Thanks Andy.

    Just to check these are for the two heat shields that run in line with each other between the turbo/downpipe/exhaust manifold and the cold air intake pipe by the cam cover?

    Next question (for full marks ) ; what are the part numbers for the heat shield fore and aft below protecting the chassis from the turbo and downpipe?

    Leave a comment:


  • Rusty
    replied
    'lower' 034 133 832 K
    'front' 034 133 832 N

    Leave a comment:


  • Lloyd
    replied
    Anyone know the part numbers?

    Leave a comment:


  • valjo
    replied
    Originally posted by Rusty
    I'm not selling anything Grega My part is not a replacement but an additional part
    Sorry Andy, my mistake

    Leave a comment:


  • Rusty
    replied
    I'm not selling anything Grega My part is not a replacement but an additional part

    Leave a comment:


  • valjo
    replied
    i bought new one from vag last year. do you need this part

    but it was way expenciver as one Rusty is selling

    Leave a comment:


  • Rusty
    replied
    Follow that thread and you'll be amazed at the difference... and all for £20!

    Leave a comment:


  • willg54
    replied
    thanks!

    Leave a comment:


  • Rusty
    replied
    It's all in this thread.

    Leave a comment:


  • willg54
    replied
    Originally posted by Rusty
    This was all part of my cone filter installation projekt.
    any pics of this? im thinking of doing some work in this area when i re-install the engine

    cheers!

    Leave a comment:


  • Rusty
    replied
    I made a further shield that attaches to the 2 M8 bolts and then goes over the turbo, easy to makes and does a great job of keeping things cooler under there I have a template somewhere that I can measure up - I just used some 1.5mm thk aluminium sheet off ebay. This was all part of my cone filter installation projekt.

    Leave a comment:


  • Lloyd
    started a topic Heat Shield?

    Heat Shield?

    I was thinking of replacing the heat shield that sits between the long black intake pipe and the turbo area as it's looking a bit tatty. Anyone know the part numbers?

    Muchos gracias
Working...