Part number

[europeanme]

anyone recognise the bushes at the end of the block??....

a part number would be spot on...

cheers
Mike

[Jamo]

http://www.s2forum.com/forum/showthread.php?t=26211

They are called dowel which is probably why they didn't show in your searches :mischeif:

[mcandmar]

014 301 153
012 301 153

01E 301 153
01E 301 153 A

01E part numbers are for 6speeds, or if converting to 3B single mass flywheel you can shorten them to fit.

[europeanme]

014 301 153
012 301 153

01E 301 153
01E 301 153 A

01E part numbers are for 6speeds, or if converting to 3B single mass flywheel you can shorten them to fit.

cheers for that....

[europeanme]

http://www.s2forum.com/forum/showthread.php?t=26211

They are called dowel which is probably why they didn't show in your searches :mischeif:

I must of had something else on my mind....

I was searching etka in the engine parts area....they are in my block so must be an engine part....

[QuattroFever]

Sorry for hijack.

Where is the engine/block number found?

[veneto rs2]

Sorry for hijack.

Where is the engine/block number found?

Engine number (ADU/AAN/ABY not sure about 3B) it's located on the right front side of the head.

Funny enough but it's there

[djh]

014 301 153
012 301 153

01E 301 153
01E 301 153 A

01E part numbers are for 6speeds, or if converting to 3B single mass flywheel you can shorten them to fit.

do you know how much do you need to shorten them by?
or can 7a one's be used?

[V6quattro]

7A ones will fit yes if you not fitting the spacer. They need shortened around 1 centimeter.

[djh]

cheers

[Tonks4x4]

Does anyone have a spacer plate to sell?

[A80Avant]

i have my old spacer plate from the dual mass flywheel days, but sits in Greece...