My wifes 2.6 v6 cabby has an injector gone,so I want to change them all. the part no for them is 078133551e.I have a set from a 5valve 2.4 part no 078133551ac these are the same colour and they are quite new. Has anyone any idea if any on the flow rates,or the effect if I use them.
-
-
Why don't you just get them serviced?? Chances are that they will all be ok after that
As for the others, well you must replace like with like if you decide to go down this route. The other thing to note is that your engine (ABC engine code) has 2 valves per cylinder, where as the 2.4 has 5 per cylinder
Drop me a PM if you want any more help or if you want your injectors tested or servicedS2 Avant......fully loaded :rock: :bow: Slipper Wagons Rule !!!!! -
Thanks for that I will bare that in mind,she needs to get the car up an running ASAP I so I guess its the nearest scrappy, I cannot put up with parrot like is my car done,is my car done,is my car done,mone,mone,mone.Why don't you just get them serviced?? Chances are that they will all be ok after that
As for the others, well you must replace like with like if you decide to go down this route. The other thing to note is that your engine (ABC engine code) has 2 valves per cylinder, where as the 2.4 has 5 per cylinder
Drop me a PM if you want any more help or if you want your injectors tested or serviced
As for the A4 injectors, there a no go as they are smaller in lenght.Comment
-
You should get the injectors cleaned and flowed anyway.
Ideally you should do that every 40 000 miles.Comment
Comment