SM flywheel Vs Auto driveplate balance

[Error404]

If I wanted to fit a SM flywheel to an engine that had been mated to an auto box, would I be able to get the flywheel balanced to match that of the driveplate, thus not upset the external balance of the engine?

[caterpillar]

the flywheel will fit on the engine when you have had out the steelpeace in the cranc.... and the flywheel cant mounted wrong; the boltholes are made to fit only in one place.... and if you dont race longraces; its ok...but there are LOT of different flywheels to audi...( thicknes, and versons)

[Jamo]

If I wanted to fit a SM flywheel to an engine that had been mated to an auto box, would I be able to get the flywheel balanced to match that of the driveplate, thus not upset the external balance of the engine?

Depends on the weight I would say not impossible though

[Error404]

So to clarify what I have in mind is to is remove driveplate from crank, have SM flywheel balanced to match said driveplate, bolt SM flywheel up to engine and use with manual gearbox, maintaining the original externally balanced bottom end