Turbo replacement!!

[Carfreak]

Buy the 034 drop in kit or ask JP to mod your wastegate

About the JP mod.. just making the house larger, fit a new valve guide ?

I think I will try to port my Rs2 wastegate and see if there´s any difference..

Right now I´m saving money for a tune session for my baby

[Carfreak]

You pay a price for fit and forget

Hehehe true But I like challenges and everything that makes it cheaper
Just need an adapter made and a screamer pipe that will be located thruw the front fender and a block off plate for the reroute in the downpipe Wish Id only kept my welder Well see how it goes!

[Jamo]

You pay a price for fit and forget

[Carfreak]

Buy the 034 drop in kit

Sadly way to expensive for me.. When I can buy the tial mv-r for about $200USD..

[Jamo]

Buy the 034 drop in kit or ask JP to mod your wastegate

[Carfreak]

Nice Thuppu although for the money but a tial / turbosmart wastegate and mate it to the manifold
Oem wastegate are so old tech when you actually see a modern wastegate

My dream is to fit a tial wg or something.. But i don´t have a welder so I can´t make the adapter for my STR ex mani

[Jamo]

Nice Thuppu although for the money buy a tial / turbosmart wastegate and mate it to the manifold
Oem wastegate are so old tech when you actually see a modern wastegate

[Carfreak]

Wastegate porn Wanna sell that one ?

[Thuppu]

It can help a little. I never tested my own after the mod... It was possible to made the seat ring only 1-1,5mm bigger without changing the valve.

[Carfreak]

Or most likely wastegate flow to low with that small A/r turbine housing.

ahh okey.. so the best thing to start with is to make the outlet of the wastegate bigger and maybe inside to ?

If that wont help I need to fit a bigger wastegate ?

[quattro84]

Or most likely wastegate flow to low with that small A/r turbine housing.

[Carfreak]

With a 35R, yes. With a 30R you will struggle if the rest of the engine is stock.

Sounds nice Well, the car will be tuned with my dekas, gt35 .64AR and with the new rods and steel headgasket.

Tryed the car today with 1,5bar of boost but I have a strange boosting issue new. The box i tuned for 1,7 bar with a 1,5bar spring with the N75 connected. But my car gives me like 2-2,2bar of boost :s Could it be the wastegate leaking ? I will buy a better one a try!

[prj]

With a 35R, yes. With a 30R you will struggle if the rest of the engine is stock.

[Carfreak]

Okey But 500bhp with stock CR ain´t no problem with pump gas (98oct) ?

[prj]

Cylinder pressure = torque.

But yeah, better not cross the knock threshold too much on E85. Especially since it can be E75 in winter, it's best to always leave a lot more margin than you normally do on pump fuel.