RS2 No boost after 30seconds of startup

[prj]

Check your marks incl. cam timing and cam belt ASAP.
Possible it has slipped one tooth. You will get the hall sender code then as well.

If not, then replace G40.

[RS2ZuidAfrika]

The G40?

i think so too. But to get to that sensor is going to be a job!
trying to look at all possibilities.

[rynaqui]

The G40?

[RS2ZuidAfrika]

this was in june

[simon20vq]

First thing first the cam marks do not aligen with the block if this is how yours is??

[A80Avant]

if you have the( ! ) look for error codes. there should definitely be some

[RS2ZuidAfrika]

OK so perhaps i worded this thread incorrectly:

http://www.s2forum.com/forum/showthread.php?t=60366

My RS2 had a boost cutout initially at about 4500rpm, but has developed into a situation where it is virtually normally aspirated all the time- except if i switch off the engine and fire her up again.

If i pull away immediately after startup, she boosts all the way through in first and second gear, very very strongly! but by third the cluster shows (!) symbol and beeps three times, after which there is no boost for as long as the car is on.

Please advise.

Avantus let me know if you had the same symptoms before you sorted your timing to "one tooth left".

Thanks chaps