AN fittings Thread size

[Fredd]

Hi
Does anyone know the thred size for various fittings on below parts. Dont have these localy so need to order. is there any guide available?

K26/K27 turbo
Example Water in M8x 1.5 ? to an6 ? right or wrong?
Water out ?

Oil out i have flange for should i use AN6 here?
Oil in i have flange for AN6 ?


Have sorted this i think

Setrab oil cooler
M22x1.5 to an 10 and then to Thermostatic Sandwich Oil Filter Adapter an10 to 3/8" npt

thx

[Sleeper_Avant]

AN sizes are not M threads, they are old school impreial if i remember rightly

i.e 3/8inch

and they are sized in - or "dash"

this should help you out, i think lol

[Sleeper_Avant]

http://www.gre6.com/ansize

damn links, click that for AN (Army Navy) sizes

[Fredd]

AN sizes are not M threads, they are old school impreial if i remember rightly

i.e 3/8inch

and they are sized in - or "dash"

this should help you out, i think lol

Ment like this one for the turbo, i know its metric but not if its 1.0, 1,025, ,1.5.... Like this one http://www.ebay.co.uk/itm/AN-4-AN4-4...6#ht_500wt_689

[Sleeper_Avant]

i see, good call.

i hope someone can help, if not i should be stripping my AAN over the next week or so and can check then for you

[Fredd]

Was quite wrong about the size, were to hardware stora today to messure the thread

Turbo side water in M12x1.5
Turbo side water out M14x1.5

M12x1.5 also fits alot of other connections lika orginal fuel rail if you wish to adapt to AN fittings with steelhose.