exhaust manifolds

[Rusty]

Link at the top, they're the ones that have been offered on here for a while.

That's some tasty workmanship for the money

[Rusty]

Looks like it works well enough - http://www.youtube.com/watch?v=hVd9i...XP8rovaZqhE5Mb

[Laaf]

Going to change my manifold from the Ebay one to a proper mild steel one. Got it welded twice last summer and the previous owner at least once.

[jsws3]

Where did that come from??

Kriskis £330 but I sent him the vband flange .

[martinjs]

These dont look too bad either, think they are £400 ish though.

http://www.ebay.co.uk/itm/S2-RS2-Aud...item337f786dae

[martinjs]

^^ i asked him for a pic of one fitted to a car and he sent me this link.

http://www.picvalley.net/u/1957/154722714219801250601355833537kYU7WTGNAAFNowlSuwLB.JPG

W/gate can be positioned anywhere the buyer wants.

[AndyP]

Kriskis £330 but I sent him the vband flange .

Quality looks good and fantastic VFM

[Nik0las]

These dont look too bad either, think they are £400 ish though.

http://www.ebay.co.uk/itm/S2-RS2-Aud...item337f786dae

I know the guys! and yes it's custom made with very very good quality...

[rj scotty]

Quality looks good and fantastic VFM

When/if I ever get to the power stage this is the manifold for me

[pasbogdan]

i would not bolt this onto any engine mate, gonna use this one for my dummy build and chop it up!

I was talking about cast ones.That one in photo is not a manifold

[Sleeper_Avant]

wish i knew the fanymoulds were so cheap, id have not wasted £150 on this paperweight i have lol

then again, i bought it so i could cut it up as it wouldnt fit the a4 chassis, hmmmmm