8A0 121 403 "C" Coolant Reservoir on ABY?

[State'd RS2 Coupe]

Stealers want $117 for proper 8A0 121 403 replacement, parts shops keep on sending me sub "A" in error and doesn't fit.

Anyone know if the sub "C" part fits? From every picture I've found they look the same and its out of a cab, so I'm hoping yes...

[UrS4boy]

Stealers want $117 for proper 8A0 121 403 replacement, parts shops keep on sending me sub "A" in error and doesn't fit. Anyone know if the sub "C" part fits? From every picture I've found they look the same and its out of a cab, so I'm hoping yes...

The 8A0121403C shows as being from a CQ with a V6.

8A0121403 works for many 80s including the RS2 and the CQ in the US. Have them look at diagram COUQ, 1990, MG 1, SG 21, 121-52.

The 8A0121403A shows being on an B3 Audi 80 sedan and Type 44 Audi 100/200 in the US. But not a CQ.

BTW, I wondered where Baz's RS2'd coupe went to when it left Seattle. Now I know.
Do you have Bay area Audi friends? I know a couple of UrS people, one in Santa Rosa.

[Mikes2]

Try the Febi 21190 reservoir

[State'd RS2 Coupe]

The 8A0121403C shows as being from a CQ with a V6.

8A0121403 works for many 80s including the RS2 and the CQ in the US. Have them look at diagram COUQ, 1990, MG 1, SG 21, 121-52.

The 8A0121403A shows being on an B3 Audi 80 sedan and Type 44 Audi 100/200 in the US. But not a CQ.

BTW, I wondered where Baz's RS2'd coupe went to when it left Seattle. Now I know.
Do you have Bay area Audi friends? I know a couple of UrS people, one in Santa Rosa.

Thanks that's what I was getting too. Just a stupid dealer price, and the usual parts suspects (AZ,ECS,Euro,RockA) don't list it or list it incorrectly. I now have 2 useless "A"s. May just order from CustomAutoCraft at this point.

Yup moved a few months back from Seattle, haven't made any contacts besides a trip over to 034, will miss the NW club, good folks. Up on jacks at the moment, replacing brakes & rotors, oil leak from pressure warning plug (PITA!!), PAS issue. The next quest is to figure out how in the world Kaz found a rear rotor to exactly match the 280x22 5x112, 40mm height specs with no indications of any tooling, washers, or other mods (cast in the USA no less!).