Quick braided PFTE Fuel line question.

[irishs2]

Can this line be used with barbed banjos , or is it specifically for an-type clamp connectors?
I thinking of using if around the avant fuel filter area, and then connect it to the flaired kunifer lines ?

Am I going about it incorrectly? Should I stick with rubber braided fuel line ?

Typo in title sorry (PTFE)

[jade]

Can this line be used with barbed banjos , or is it specifically for an-type clamp connectors?
I thinking of using if around the avant fuel filter area, and then connect it to the flaired kunifer lines ?

Am I going about it incorrectly? Should I stick with rubber braided fuel line ?

Typo in title sorry (PTFE)

I just take mine to my local hydraulic specalist and get them to press them on with collars

[Tonks4x4]

When I fitted it on mine and Vas's car

I used one of these on the PTFE hose


AN -6 (AN6) STRAIGHT Steath Black Teflon Hose Fitting

http://bit.ly/ZIgZ7m

And then screwed in one of these

AN -6 (AN6) Male To 7- 8mm Hose Barbed Fitting in Black

http://bit.ly/ZgvAue

And then used a small length of rubber hose and 2 jubilee clips to join from PTFE to the top of the tank

Pictured here is the original


Pictured here is the PTFE


However to cut down on joints and having the fuel filter in a rubbish place we also used one of these....

And it gives a better flow rate too. And can be washed out and re used.

AN 6 (AN6) Black Anodised Billet Fuel Filter 100 Micron

http://bit.ly/ZBNCGZ

The filter was then mounted in the engine bay for easy access

[irishs2]

Thanks for that, thats exactly the info I needed.

[mushasho!]

How long of a hose did you end up needing to go from the sender to the rail?

[Tonks4x4]

How long of a hose did you end up needing to go from the sender to the rail?

I have run my fuel lines in a different direction to stock, so you would need more to run the standard route.

I would guess 11meters should just about see you with enough and a little spare.


Tonks4x4 - The Land Rover Specialist

[mushasho!]

I have run my fuel lines in a different direction to stock, so you would need more to run the standard route.

I would guess 11meters should just about see you with enough and a little spare.


Tonks4x4 - The Land Rover Specialist

11 Meters sounds like alot from the sender to rail. I'm only upgrading the send hose not the return. Which route did you use?

[Tonks4x4]

The 11 meters was from tank to rail and back with a little spare.

The route I have taken is from tank to front of car without crossing over from left to right and right to left underneath.


Tonks4x4 - The Land Rover Specialist