rs2 start problem again

[fatiii]

hi all. i know tried of me the all off but there's no one else to help you..

i have a new problem.i opened the engine for upgrade rods,studs,cams vs vs.but after collecting the engine will not start..i think timing is very well but what is your thinks?

the ignition and fuel running smoothly

the krang timing calibrate the top of the first piston.is it true?

it is cams timing..

and the last one sorry my bad english

[david]

check the marking on cambelt pulley i think it's in line and probably that's where the problem is.
it well known that rs2 timing do not line up properly,you need to line it one teeth back.
checckout the pics

[irishs2]

It shouldn't stop it from starting , just prevent boosting. Anyway I think this is an not an adu engined rs2 if I remember correctly..

[david]

It shouldn't stop it from starting , just prevent boosting. Anyway I think this is an not an adu engined rs2 if I remember correctly..

yes it will if timing is even slightly out

[Avantus]

My RS2 wasn't one tooth left when I bought it, causing it to cut out at something like 4k rpm with a hall sensor fault. It did start perfect however so I think you need to look further.
Didn't damage the sensor?

[david]

It shouldn't stop it from starting , just prevent boosting. Anyway I think this is an not an adu engined rs2 if I remember correctly..

irishs2

if it not ADU and it a ABY then something else must be wrong

[irishs2]

It started out as a 3b but cannot remember where it ended up.

[fatiii]

check the marking on cambelt pulley i think it's in line and probably that's where the problem is.
it well known that rs2 timing do not line up properly,you need to line it one teeth back.
checckout the pics

how is it now?

[fatiii]

it is working perfectly about 400 hp but i want more power so open the engine for upgrade..

[A80Avant]

Looks better now. Try it

[fatiii]

Looks better now. Try it

the krang timing calibrate the top of the first piston.is it true?

What is your thinks?

[stocious]

Why do the cam wheels have flat teeth ? Are some like that ?

[stocious]

Is it still on a distributor ?

[UrS4boy]

It started out as a 3b but cannot remember where it ended up.

That is correct. (but We won't start that thread up again)

Fatii doesn't say whether he is running the 3B distributor (and G40 Hall sender or not).

The cam sprocket he is using is the ADU 105B (where B = ADU).

[A80Avant]

From memory I think he is on coils and vems