head removal issues

[jamie9048]

hi spent a few days removing the head from my car and id like to thank the inventor of wd40

any way the head is off and awaiting the head shop reopening in the mean time what is this part think i may have broken it whilst removing it


also can you get the rubber seal/ tip for the injector as one is split

cheers jamie

p.s. happy new year

[jamie9048]

the part in question is the one with the spring poking out

[nip]

hi spent a few days removing the head from my car and id like to thank the inventor of wd40

any way the head is off and awaiting the head shop reopening in the mean time what is this part think i may have broken it whilst removing it


also can you get the rubber seal/ tip for the injector as one is split

cheers jamie

p.s. happy new year

It's hard to see looks like something to do with the charcoal canister , that goes into the inlet n80 valve part, one way valve

[rj scotty]

One way check valve from pcv system by the looks of it. It's cheap and you want to replace it anyway

[jamie9048]

where is the best place to get head bolts from as tps want £8 plus vat each gulp

[Laaf]

http://speed-autoteile.fi/index.php?route=product/product&product_id=4008

Victor-Reinz 14-32049-01. You should be able to source these more locally, should be around 50-60€ for the set.

[Error404]

Yup that's the one-way valve that stops you boosting the crank case. Probably worth replacing even it wasn't visually damaged

[AndyP]

Cheapest I can find

http://www.bestpartstore.co.uk/1878969

[jamie9048]

cheers fellas are payne bolts suitable they dont have the rifling like the ones andy found and whats fitted to my car

seen these on ebay but I get them from our parts suppliers

http://www.ebay.co.uk/itm/AUDI-2-2-T...item4171e81fd2

[SteveH]

The eBay add says the picture is generic and you will receive the correct parts for the vehicle. They should be stretch bolts or you could spend a bit more and get ARP's. They are worth the additional expense if you think you will have the head off a few times.

[jamie9048]

aye sorry did not read the description was rather tired last night

i did order a gasket and bolts from andrew page last week and the bolts did not have the twist on them so i returned them

[anthonys2]

Jamie you will be pleased when all your work is done on it!! Since you have owned the car you have done loads of restoration work hope to see it soon??!

[mcandmar]

If you can find the little black plastic disc you can reassemble that valve as it doesn't look damaged, they are only held together with clamps.

[jamie9048]

ha ha yes its been a journey lol i had it all but done, its had its paint job done all new brakes and clutch, the whole underside renewed...

suppose the thing that got over looked whilst it was abandoned on the four poster was the hot running issue but its a promise to my self that this year its going to be on the road so hopefully i can attend a meeting and meet up with a few s2 owners/forum members.



pcv valve is replaced only cost £8