Whilst the car is on the ramps (again) i thought i would fit the SFS IC to x member hose thing. Im sick of replacing these 'o' rings. 2 in 3 months now!! When i looked inside the IC it was full of oil in the bottom of it.
I think this is the result of the valve stem oil seals leaking for a while. @Mark may be worth looking at yours m8.
Anyway changed the VS oil seals a while ago and never cleaned the IC.
I have now cleaned it right out, loads of oil sludge buildup in the bottom of it. I used a de-greasing bath at work to remove the oil. Just stuck the hose bit in one end and let it run through for about 30 mins or so.
This may bring inlet temps down a little?
I think this is the result of the valve stem oil seals leaking for a while. @Mark may be worth looking at yours m8.
Anyway changed the VS oil seals a while ago and never cleaned the IC.
I have now cleaned it right out, loads of oil sludge buildup in the bottom of it. I used a de-greasing bath at work to remove the oil. Just stuck the hose bit in one end and let it run through for about 30 mins or so.
This may bring inlet temps down a little?
Comment