multi rib belt crank pulley

[malncol]

iam about to get the AAN back to put in the s1e2 project and i need to know some more about the belts and adjusters.
Its a 034 bottom pulley for multi rib flat belt not vee so as i have never seen a S2 engine with this belt does someone have a front on pic for me to have a look at??
Also iam running 034 inlet so i have to mod the power steer bracket???
thanks
mal

[Error404]

Hi Mal,

Not quite sure what you're asking?
Not sure about the 034 pulley, but the AAN has a single serpentine belt driving alternator, PAS pump and AC pump.
ABY has a vee each for the PAS pump and AC compressor and a multi-vee for the alternator.

As you're motor is far from stock, it would help to know what ancillaries you're planning to run off the engine.

If the 034 IM is a rebranded Wagner, then AFAIK you just need to run a shorter PAS belt.

[malncol]

Hi Mal,

Not quite sure what you're asking?
Not sure about the 034 pulley, but the AAN has a single serpentine belt driving alternator, PAS pump and AC pump.
ABY has a vee each for the PAS pump and AC compressor and a multi-vee for the alternator.

As you're motor is far from stock, it would help to know what ancillaries you're planning to run off the engine.

If the 034 IM is a rebranded Wagner, then AFAIK you just need to run a shorter PAS belt.

thanks yes i need to run power steer ,alternater with the single serp belt , but when i got my aan sent over it was missing the pump,alt and brackets etc so i havent got a clue on what i need or whats missing
thanks
mal

[UrS4boy]

AAN Serpentine Belt and Belt Tensioner info

iam about to get the AAN back to put in the s1e2 project and i need to know some more about the belts and adjusters. mal

This might help you:

http://forums.quattroworld.com/s4s6/msgs/22579.phtml

[malncol]

****** iam missing pretty much all of it, guess ill have to make some brackets etc
thanks
mal

[malncol]

RE: brackets as we didnt get AAN engines here would it be possible to use brackets etc from 2.5 out of transporter ???
Also the diagram kindly supplied above shows AAN with AC , did they do a no aircon set or where they all AC???
thanks
mal

[UrS4boy]

RE: brackets as we didnt get AAN engines here would it be possible to use brackets etc from 2.5 out of transporter ??? Also the diagram kindly supplied above shows AAN with AC , did they do a no aircon set or where they all AC??? thanks mal

Since the transporter is a VW and the AAN is Audi, checking PN cross-overs is not easy. What is possible is similarities to the AAR 10V naturally aspirated C4 inline-five available in some markets.

If you had clicked on the link I provided your second question would have been answered with this (A/C and non-A/C serpentine belt PNs):

[malncol]

thank you for that info, i think the bits are going to really hard to find here in OZ
thanks
mal

[malncol]

ok for this to work iam going to need items 6,9,13,17,22 to suit AAN
anyone be able to help
thanks
mal