Guide to replace ABY ECU maps

[HenryG40]

Hi,

Can anyone supply a guide to replacing the maps on an ABY ECU? I'm aware the originals are soldered in, and I already have the ECU removed. A bit of guidance on opening the casing and any tips would be useful before I get stuck in

Cheers

[Sonic]

1. Bend metal flaps straight with a flat screwdriver or pair of needle node pliers. Be prepared to snap a few after doing this several times.
2. Remove torx screws.
3. Slide off metal cover to reveal the boards.
4. Separate the 2 plastic pin clips by pulling apart carefully.
5. The next bit is a bit tricky until you've sussed it - but you need to separate the 2 boards by pressing in the 2 tabs on either side of the pins where the connector is with a flat blade screwdriver then pushing the top board down out to separate and open the boards like a book.

I'm certain there'll be a good guide somewhere with photos, but not got time to find it for you just now.

[andy10v]

Step by step how to with pictures

http://12v.org/urs/Bob%20Myers%20ECU%20Opening%20Instructions.pdf

[HenryG40]

Cheers for the help guys, have just split the ECU and it's ready for soldering.

To help anyone else going through this process, this guide was also very helpful

http://www.quattro123.com/MPTSAudiECUupgrade2.htm

[UrS4boy]

Or this:

http://12v.org/urs/Bob%20Myers%20ECU%20Opening%20Instructions.pdf

[andy10v]

Or this:

http://12v.org/urs/Bob%20Myers%20ECU...structions.pdf

The one which is post No. 3?

Getting slow Dave

[UrS4boy]

...Getting slow Dave

Not slow. Just quickly stupid