Can anyone confirm the size of MAF-Turbo hose needed for K26/27

[WidowmakerS2]

Im in the process of changing to a K26/27 turbo.

After fixing the DP wastegate pipe, I thought start-up was within reach, but I seem to have encountered another niggle.

The MAF-Turbo hose intake side is too small! I always thought it was the other way around.. My original 3b hose has the same outer diametre as the turbo intake now.

I can't see any way to fit anything in between either, space wise..

What do I need to buy now?

[Lloyd]

You need a 70mm length of silicon hose, 70mm ID which goes over the end of the standard MAF/Turbo and mates it to the larger K26/27 turbo inlet. You will also need a short section of stainless steel tube as an insert to all you to clamp the two silicon hose together. Stainless Steel (57mm OD x 33mm long)

[WidowmakerS2]

Thank you!
I found a pipe cut from 2,25" exhaust fitted perfectly.