a friend of mine told me that i shuld use adu berings for the 3b intead of the 3b berings. are they better?
-
ABT C5 Lord Of The Rings
2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
kostic.nu -
Yes. 3B originals should not be even available anymore.- -
ok thnks.ABT C5 Lord Of The Rings
2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
kostic.nuComment
-
ADU RS2 connecting rod bearing - sputter treatment
Hello,
The question is relevant and who knows the company that makes the RS2 ADU connecting rod bearings ? Material is specially treated and far more better than others.
This knowledge probably might offer a good way to save in the bearings area if the original vendor and partnumbers are found.
This is one candidate:
Glyco Catalog :
UK:
German:
Does someone have that info ?
Is the "SPUTTER" treating the special treating in stock RS2 CR bearings ?
71-3732/5
Eng/Mot. S2/S4/S6/RS2 : 162/169/232kW 220/230/315PS)
BE/PL 5 47.758/47.778 50.600/50.612 19.000 1.395 GLYCO 71-3732 71-3732/5 STDLast edited by Tommy200rs; 3 February 2005, 07:54.Comment
-
I have heard that the sputter are the RS2' s upper Rods bearing in the big end! The bearing on the downside are not so hard as they supposed to integrate "dirt" from the oil, so that the big end of the rod don't scrub! If the oil is changed earlier than 8000 Kmh then if you want you can go for sputter up and down on the big end!Go Holset or Go RS4Comment
Comment