Here you go Sal.
Sal_S2 Dyno plots
Collapse
X
-
And the next oneAttached FilesS2,RS2,S4 WB,RS4,S4 B8,RS6 C5,RS6 C6,R8 -
And the last oneAttached FilesS2,RS2,S4 WB,RS4,S4 B8,RS6 C5,RS6 C6,R8Comment
-
Definatley looks like a leak to me. I had mine on a dyno when it was stock and before it had a leak the torque was pretty much flat form just under 3000 right up to 5500 rpm.
Mine feels like it is doing the same as yours now Sal. The boost drops right off from 3000rpm onwards.
Do you have a boost guage, that would show a leak if the boost was dropping?
HTH
LeighEx 1994 Avant - now driving a Lotus 340r
Comment
-
The 208 bhp is your power at the flywheel,so you are approximately 20 bhp down on what you should have for an ABY lump, ie 230 bhpOriginally posted by sal_s2
I always thought that my overboost didnt last for long enough but if I had a leak, would I still get 208hp at the wheels?S2 Avant......fully loaded :rock: :bow: Slipper Wagons Rule !!!!!Comment
-
I was told that the power was measured at the wheels and that the flywheel power was close to 250 bhp. This figure seemed a bit optimistic to me but the guy reckoned that their system was very accurate.
It wasnt a rolling road as such. The wheels were taken off the car and clamps were attached to the hubs which slotted into four boxes (1 at each wheel) attached to a computer.Comment
-
And your point is :nana:Originally posted by Martynf
Paul, do us a favor mate, and let your mouth do some talking for once!!
MartynS2 Avant......fully loaded :rock: :bow: Slipper Wagons Rule !!!!!Comment
-
no point really... just felt like abusing you... verbally this time ;-)) :nana:Comment
Comment