Camshaft regrind

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Billman
    S2Forum Freak
    • Nov 2004
    • 4129

    #1

    Camshaft regrind

    Hi,

    I have a set of ADU camshafts not fitted and a pair of AAN camshafts. Is it possible to regrind the AAN camshafts to ADU spec to have them as spare?

    Anyone done this?
    Last edited by Billman; 15 December 2014, 10:57.
    Go Holset or Go RS4
  • as2nerka
    S2Forum Enthusiast
    • Mar 2009
    • 149
    • Home: Sweden

    #2
    regrind

    yes its

    Comment

    • as2nerka
      S2Forum Enthusiast
      • Mar 2009
      • 149
      • Home: Sweden

      #3

      Comment

      • willg54
        S2Forum Fiend
        • Jun 2009
        • 2055
        • Country: United Kingdom

        #4
        Piper did this for me on a yamaha r6 camshaft. Cost about £90 iirc
        1996 Audi S2 - 295bhp and 326lb/ft - Complete Rebuild Project

        1994 Audi 80 - 2.0 8v (slow but reliable!)

        Comment

        • Billman
          S2Forum Freak
          • Nov 2004
          • 4129

          #5
          Can someone please confirm if the AAN vs ADU intake is the same so no need to change something there just cut the shaft at the end (where the dizzy goes).

          Also confirm these specs:

          ADU: duration 205°, lift 9,5mm
          AAN: duration 213°, lift 8,6mm
          Go Holset or Go RS4

          Comment

          • Billman
            S2Forum Freak
            • Nov 2004
            • 4129

            #6
            The AAN intake and ADU intake are interchangeable?
            Go Holset or Go RS4

            Comment

            • A1quattro
              S2Forum Maniac
              • Jul 2006
              • 789
              • Country: United Kingdom

              #7
              intake cams aby ,adu .aan are same just ex cam is different [ the cam wheel for adu gives the 10% advance timing for both cams]

              Comment

              • Billman
                S2Forum Freak
                • Nov 2004
                • 4129

                #8
                I see, thanks
                Go Holset or Go RS4

                Comment

                Working...