3b engine rebuild info required.

[andy10v]

Thanks I will, I'll print off the manual tomorrow to keep on the work bench, has anyone got the timing marks for the crank, cams. I know the cams have 2 dots that line up are they the only timing marks for the cams?

Flywheel 0 (just so you can see the 0 and the -)



Aligned



Dizzy (bad picture, all the marks should be in line when viewed from the right angle)



Get a new crank sprocket £30 ish, or upgrade to a billet one £100ish. Stock ones can break.

[bartolomeus]

Sorry for the off topic but maybe this will help you?
I have an AAN engine completely overhauled, engine builder is Pas Bogdan, the engine has new pistons, redone head etc, it's 500 km since new, the previous owner's car burnt after only 500 km of use He had an S4, the battery problem... That's user Marius555
The engine comes 100% complete + ECU LOOM CLUTCH 01E gearbox.

Maybe you want to save time and money...????

[Tomhorner]

Flywheel 0 (just so you can see the 0 and the -)



Aligned



Dizzy (bad picture, all the marks should be in line when viewed from the right angle)



Get a new crank sprocket £30 ish, or upgrade to a billet one £100ish. Stock ones can break.

Spot on thanks I thought they were the ones just double checking I've taken the flywheel already off mine before it went to the rebuilders and the head so it's just the block crank and pistons at the moment I had the head skimmed and pressure tested so that's good to go.. Hopefully get it picked up this week so I can make a start..

[Tomhorner]

Sorry for the off topic but maybe this will help you?
I have an AAN engine completely overhauled, engine builder is Pas Bogdan, the engine has new pistons, redone head etc, it's 500 km since new, the previous owner's car burnt after only 500 km of use He had an S4, the battery problem... That's user Marius555
The engine comes 100% complete + ECU LOOM CLUTCH 01E gearbox.

Maybe you want to save time and money...????

Thanks for the thought I'll bear it in mind, I'm going to give mine ago first with the money I've spent onit parts ect.. if it goes wroung I maybe in touch haha!

[Tomhorner]

I got my engine back today and have managed to get the crank, conrods and pistons stripped, the main bearings are quite scored! Also got some pictures of the new main, big end and thrust washers..
http://

[/IMG]

[Tomhorner]

[Tomhorner]

Here is some of the residue left in my sump..

[Tomhorner]

[Tomhorner]

[Tomhorner]