You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
Help! Oil in coolant after head gasket replacement
I wouldn't tighten them any more than what's specified in the ARP instructions unless others have BTDT's on the subject. The last thing you want is to potentially strip a thread out! You could always slacken each one off a few lbs/ft and then re-torque to the correct value again. I think that if they were torqued up properly to begin with then this wouldn't achieve anything though...
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment