Need a remap on my RS2 with K26+Tubular manifold

[paulmullin]

Hi Guys,

I need some advice on where to get a remap sorted for my RS2 I have a 'hybrid' K26 and tubular manifold to fit to it but I need somewhere to get it mapped to these changes...

I am based in the north west and would appreciate some advice on somewhere good to go for a remap.

Thanks in advance.

Paul

[andy10v]

Mark at Automark.

[Rikki Kitto]

http://www.automarkuk.com/:thumbs:

[paulmullin]

Hi Andy and Rikki, Thanks for the tip Ill get in touch as soon as the cars built up and see if they can sort it for me.

Do either of you know will I be ok to drive the car (gently) to the garage on the standard map or should I trailer it there?

Cheers,

Paul

[Cordoba16vt]

Off boost you can drive your car with any turbo you like ...

[Teg]

But who wants to drive anywhere off boost!!!!!haha

[paulmullin]

ok so if I take it easy ill be ok (that will be a challenge!)

What do you think I could expect BHP wise with these mods after a remap?

[Rikki Kitto]

Disconnect the N75 valve

[paulmullin]

Rikki,

Is that to protect the engine before I get it remapped?

[GazzaG60]

it may bog down on set off. if you don't use the airbox and I suspect you don't get a leg off a pair of tights. put it over the maf. temporary air filter. I did this. drove mine on motronic with tubes and sc61 back from Nottingham like that to sunny Manchester, no issues

[Rikki Kitto]

Rikki,

Is that to protect the engine before I get it remapped?

Yes it will only boost to 0.4bar max with the N75 disconnected that is what i did recently, it's very difficult not to boot it when you're driving about, for me anyway so I thought it best before I risked killing the engine