Dip stick tube fitment?

**wug** · 21 March 2016, 19:37

According to Etka, yes, they can be removed. Not sure about the procedure.

Sent via Crapatalk

**Error404** · 21 March 2016, 19:43

ABY / AAN just pull out.
3B / 7A are pressed in you need to knock them out from inside the crank case

**diesel des** · 22 March 2016, 06:59

Careful here. I cracked a block once knocking out one!

Sent from my LG-H955 using Tapatalk

**Nuvo** · 22 March 2016, 08:41

Good info, thanks chaps.

**AndyP** · 22 March 2016, 08:58

Originally posted by diesel des

Careful here. I cracked a block once knocking out one!

Sent from my LG-H955 using Tapatalk

What were you using, a 14lb sledge hammer??!

**diesel des** · 22 March 2016, 12:03

Started off gentle with plenty of lube but then gradually increased force in till in came off on my hand lol.

Sent from my LG-H955 using Tapatalk

Comment