Dyno Test - Disapointing ?

[RS2junkie]

Hi,

I had my RS2 on a dyno test recently, I was a little surprised (disappointed ?) by the results. It recorded 330bhp. I have the following modifications
- PRJ Remap
- TFSI Cols
- Miltek Cat back exhaust
- 3" exhaust and downpipes

Perhaps I am expecting too much but the car pulls very strong, better than before the remap. BUT, before the remap, and the modifications, exhaust etc, it recorded 335bhp ! I guess its the torque..


Paul

[treebirch]

Hey Paul,

Don't be too down on the ol' girl!

Have you been through the process of a boost leak test? I've almost identical mods' (bar the down pipe) but replaced crank case breather valve, N75, diverter valve, new plugs, a new fuel pump and few cans of Castrol Magnatec!

You've probably done all those though.

Bon courage!

Mark

[AndyP]

Were the 2 dyno runs done on the same dyno?

[kinaputt]

Intake temps is also important.

[Rusty]

What were the AFRs? That'll tell you if it's running the right fuelling / boost leak at least.