K26 swap and DTA Stand Alone on 3b????

[audspeed]

Anyone know how much HP i can get from stock 3b s2 engine with an K26 swap and Dta Stand Alone system?

[porkkis]

Well, it depends on the K26, doesn't it?

You'll have to change other bits too.

[audspeed]

Other bits??? Any help what???

[porkkis]

Injectors and IC atleast.

[audspeed]

ok what about 42Lbs 440cc injectors and custom IC at stock location???

[porkkis]

Well that one looks a bit like a cooler but is smaller! Everyting isn't big in the states afterall

[audspeed]

it's not tha small how it seems. It should be able to produce 400-450hp???
Core size: 17.5" wide X 6" tall X 3" deep
Overall: 23" at the widest X 12.25 at the tallest X 3.125 at the deepest
Inlets: 2.5" Outside Diameter with a bead
Core Flow: 570 CFM

[Audi Parts Guru]

pp

[Audi Parts Guru]

Have you personally done any tests on this core with regard to efficiency?

[audspeed]

Not really but it is the same cooler as they use on V8 single turbo set up for Mustangs. Actually Spearco sells them. It is one of the best US brands that you can find for coolers.......

[Doug_RS2]

Have you used the DTA system before?

034EFI is a similar aftermarket engine management system but they have been used on the the 5 pot 20 valvers before - you might get more support if you used that system. They also sell turbos matched to your car and are in the states http://www.034efi.com/

[kwlw]

Anyone know how much HP i can get from stock 3b s2 engine with an K26 swap and Dta Stand Alone system?

If I'm not mistaken, if you use KKK26 turbo from urq or MC engine, you should end up at 260 hp ... Not much, isn't it ?

Other story with different hot and cold sides, and turbos from porsche, etc.

Sau