S2 Undertray part number anyone?

[PeterS]

Ladies and Gents...

I'm trying to make sense of the partnumbers in ETKA for the S2 engine undertray - my understanding is that the Coupe and S2 have the same part number but different suffix...

I searched the archives, but could not find the defininite part number.

Does anyone also have an idea of the cost of a new one from Audi?

Thanks as always!

-Peter

[Fat Audi 80]

Is it a bird?

Is it a plane?

(It looks too round to be a plane?)

Its........

[PeterS]

Is it a bird?

Is it a plane?

(It looks too round to be a plane?)

Its........

It's NOT Captain Obvious.....

[Mikes2]

8G0 863 821 B unless you have lhd and the rodent protection system in which case you'll need 8A0 863 821 H

It does say "adapt with workshop equipment" for the standard part.

This is for N chassis onwards.

[Fat Audi 80]

It's NOT Captain Obvious.....

I have been let down by S2Avant aka "Parts Daddy"

I was sure he would be along shortly. Must have left his cape at home...

[PeterS]

MikeS2:

Its a bit more complicated than that ...
I bought a lhd S2 bumper from the spanish and am installing it on my 1991 Coupe Quattro (7a 2.3 ltr) that I am converting into an ersatz 3b S2...

So I have LHD and no rodent protection system

[Mikes2]

So you'll need 8G0 863 821 B which also fits M chassis.

[s2avant]

Never fear I am here......Parts Daddy Returns (opening summer 2006)

Peter,

The bumpers aren't handed but I'm assuming your car is left hand drive. Not that it matters as the part number is 8G0 823 821 B for all years now irrespective of LHD or RHD. As mentioned above you'll probably need to do some cutting/drilling etc as it is listed as adapt with workshop equipment.

They retail at £145.16 + VAT over here.

Ben

[s2avant]

Is it a bird?

Is it a plane?

(looks too round to be a plane?)

Its........

What's that supposed to mean, Fatty?

[Fat Audi 80]

[PeterS]

Never fear I am here......Parts Daddy Returns (opening summer 2006)

Peter,

The bumpers aren't handed but I'm assuming your car is left hand drive. Not that it matters as the part number is 8G0 823 821 B for all years now irrespective of LHD or RHD. As mentioned above you'll probably need to do some cutting/drilling etc as it is listed as adapt with workshop equipment.

They retail at £145.16 + VAT over here.

Ben

Ben:
It makes sense now...the US spec bumpers of course ???!!! have a different belly pan....so I need to get a pan for one of the non US CQ bumpers...

THANKS!
-Peter