New Wing

[dhali7376]

THANKS to everyone for their input.

[GT500]

Best done with a "Q max" cutter (ebay) just measure your hole for the size. 25mm springs to mind...
I'll find the link to Alex's resto project about the coatings.
Most important to get a covering were the arch liner rubs against the folded edge. All 80s/coupes rust due to the liner fidgerting through the paint and galv.

[dhali7376]

Of that I do not know unfortunately, I'd ask GT500 and S2avant as I'm sure they would know

pms on there way

[Jamo]

Of that I do not know unfortunately, I'd ask GT500 and S2avant as I'm sure they would know

[dhali7376]

Audi RHD wings will have no indicator holes also, you have to cut them in.

any speacial tool required? or just a a reasonable sized bit and a file??

[Jamo]

From the man from Audi http://www.s2forum.com/forum/showpos...9&postcount=17

[dhali7376]

Dal make 100% sure when you order that they order RS2 rhd wings... S2/80 avant wings have an oval Audi badge hole low down and lhd will not have the indicator holes. Pm Rob GT500 he will be able to advise

thanks Al, made sure they were RS2 as i was looking at the Etka screen as he was sourcing the part numbers.

[Jamo]

the holes for the trim should be drilled, mine were. You will need the captive nuts that go on the lower, front of the wing.

RS2 and Coupe wings are different

[shaun5]

the holes for the trim should be drilled, mine were. You will need the captive nuts that go on the lower, front of the wing.

[Jamo]

Dal make 100% sure when you order that they order RS2 rhd wings... S2/80 avant wings have an oval Audi badge hole low down and lhd will not have the indicator holes. Pm Rob GT500 he will be able to advise

Audi RHD wings will have no indicator holes also, you have to cut them in.

[Al Wyn]

Dal make 100% sure when you order that they order RS2 rhd wings... S2/80 avant wings have an oval Audi badge hole low down and lhd will not have the indicator holes. Pm Rob GT500 he will be able to advise

[dhali7376]

thanks AGAIN John

[john johnson]

Ask gt500 on here regarding proofing, I had a pair of new wings fitted to one of my ur's last year and they seriously went to town proofing them with a factory spech product then painted the wings off the car, but they were £1300 just fir the wings so I deffo wanted them proofing!

[dhali7376]

The new wing probably wont have a hole in it for the side repeater so you'll need to drill it before you paint it

will the holes be there for the side strips or will i have to drill those too?

[dhali7376]

I always stone-chip and paint the inside and anywhere else that ain't visible, I'm an amateur though. The more professional body-workers on hear may have different ideas.

cheers

rich

would it be a good idea to use some sort of wax coating too?