Rust killer

[pasbogdan]

Clean the rust with wire brush on the angle grinder or on drilling machine.If in the process the area gets black collor means the only way to get rust out is sandblast etc.Best way on 100% clean metal is to use epoxy primer with a layer of paint.

[GT500]

Just had a dig about, those 1kW units are $480,000

I'll sell the RS2 and buy one. 😊

[Error404]

Just had a dig about, those 1kW units are $480,000

[GT500]

Holy ****! That thing is awesome!

Yep. Where do they sell those?

[Error404]

in a couple of years we`ll all have this at home:

https://www.youtube.com/watch?v=CLaBFkeHG0A

Holy ****! That thing is awesome!

[Michael S2]

Have used bilt hamber and it does a great job. Have got loads leftover if anyone wants it.

http://www.s2forum.com/forum/showthread.php?t=78904&highlight=bilt+hamber

[AndyP]

Primer + Stonechip is NOT water/oxygen proof....

As above, use a proper top coat, and THEN think about using a stonechip if it is vulnerable to that.

This maybe the issue, primer I knew wasn't waterproof, but I assumed stonechip was. I'll strip it off and put some top coat on before stonechipping again.

Thanks

[hiloran]

I have used http://www.bilthamber.com/corrosion-...ments/deox-gel
Spread, leave it for short time, brush, wash few times and it is good for primer.

Best would be: http://www.bilthamber.com/corrosion-...atments/deox-c

but I´m not sure if you want to dip your car

[Skull]

Apparently they cost way over $100k so I doubt that

i said in couple of years, by then the chinese will be making them and youll get them for £50

[hunker7]

in a couple of years we`ll all have this at home:

https://www.youtube.com/watch?v=CLaBFkeHG0A

Apparently they cost way over $100k so I doubt that

[vonbeck]

Hi Andy i`ve used this

http://www.bilthamber.com/corrosion-protection-and-rust-treatments/hydrate-80?___store=default

they do some pretty good stuff

[Skull]

in a couple of years we`ll all have this at home:

https://www.youtube.com/watch?v=CLaBFkeHG0A

[gnutz2]

Primer + Stonechip is NOT water/oxygen proof....

As above, use a proper top coat, and THEN think about using a stonechip if it is vulnerable to that.

Depends on what primer you use.

[Bowie69]

Primer + Stonechip is NOT water/oxygen proof....

As above, use a proper top coat, and THEN think about using a stonechip if it is vulnerable to that.

[diesel des]

https://www.youtube.com/watch?v=WgiecR6LzwA
Not tried one but they look s**t hot

It's not leaving much of a prepared surface like blasting does. A sa of about 3 is ideal and easy to get with blasting.

Sent from my LG-H955 using Tapatalk