RS2 intake vacuum fitting part number

[saltinot]

That 034 133 347 number doesn't seem to exist...?? I **think** the part is either 034 133 382T (8mm) or 034 133 382AG (5mm).

Yes, I too have found the 034 133 347 number not to be valid. The two part numbers you listed do not cross referrence to the RS2. Have you ever ordered either of the two parts you listed above?? Thumbing through ETKA they don't seem to be what I'm looking for. But then again, the illustrations in ETKA have never been an accurate representation of reality. Thanks for your help.

[Martynf]

That 034 133 347 number doesn't seem to exist...?? I **think** the part is either 034 133 382T (8mm) or 034 133 382AG (5mm).

[saltinot]

Hi!,

I think I made a note of this as it was on Jimmy Pribble's e/s2 site. His RS2 manifold was provided without this part. I don't think it is listed on the EKTA. Somebody who had accesss to factory info gave him this part number: 034 133 347. Worth a shot!
Looks as though the whole S Org site is unavailable at the mo. I think it is archieved on there.
I think this is the one on the very end of the manifold which looks as though it screws in as it has a hex on it.

Thanks. Even with the site down I was able to access the info using the Wayback Machine internet archiving doohicky. I was able to confirm the number that you gave. so now I just need to find someone with the part!

[Fat Audi 80]

Vagparts.com....

[twoqu]

Well, I broke off the vacuum fitting on my RS2 intake. It's the one towards the front of the car that provides pressure (when the throttle is down) to the the back side of the bypass valve.

Does anyone know the part number for this part? Or is there a source for a replacement besides Audi??

Tom

Hi!,

I think I made a note of this as it was on Jimmy Pribble's e/s2 site. His RS2 manifold was provided without this part. I don't think it is listed on the EKTA. Somebody who had accesss to factory info gave him this part number: 034 133 347. Worth a shot!
Looks as though the whole S Org site is unavailable at the mo. I think it is archieved on there.
I think this is the one on the very end of the manifold which looks as though it screws in as it has a hex on it.

[saltinot]

Well, I broke off the vacuum fitting on my RS2 intake. It's the one towards the front of the car that provides pressure (when the throttle is down) to the the back side of the bypass valve.

Does anyone know the part number for this part? Or is there a source for a replacement besides Audi??

Tom