A question to those that have made their own (or modified a standard one). I plan on taking a 3B item cutting it at the point where the runners go into the main body, turning the body through 180 degrees about it's length and rewelding it, to make it a front inlet.
With it being cast aluminium is that going to create a problem? I have all the euipment to weld ally (mig and tig) but have only welded ally sheet not cast before. I am going to mig it but would like any BTDT's.
With it being cast aluminium is that going to create a problem? I have all the euipment to weld ally (mig and tig) but have only welded ally sheet not cast before. I am going to mig it but would like any BTDT's.
Comment