Exhaust manifolds

[K7ERG]

Any good for a AAN engine. I am looking to get as close to 450hp as i can

http://cgi.ebay.co.uk/Racing-Exhaust...QQcmdZViewItem

http://cgi.ebay.co.uk/S2-S4-S6-RS2-AUDI-TURBO-MANIFOLD-

Item number: 250087103055

[zlobo]

bougth one for a fend of mine and i hadd a look at it whwn i recived it.... some weldings was minimal on this one i recived, and the colector was not so nice.. but it will do for 450hp i think.. we are going to run 450 on the one i bought for my frend.

[K7ERG]

Thanks for the reply

[K7ERG]

Will a garrett Gt3071R fit the top manifold?

Craig

[s2_bo]

Nope,
Auctions states:

KKK24, KKK26 (76x38mm) turbo flange.

So no good for Garrett turbos.

[K7ERG]

Missed that bit.

Are the garrett and KKK mounting holes not close?

[Jamo]

Nope,
Auctions states:

KKK24, KKK26 (76x38mm) turbo flange.

So no good for Garrett turbos.

Thats only if you buy a Garrett directly

If you buy a garrett from Corey or 034 it's machined to fit a K26 flange i.e an S2/RS2 flanged manifold.

[K7ERG]

So the flange can be machined to suit a garrett?

Craig

[Jon441cc]

Will a garrett Gt3071R fit the top manifold?

Craig

Is the GT3071R hotside pure garrett T3... if so it will fit on this

http://cgi.ebay.co.uk/Kruemmer-Heade...QQcmdZViewItem

[K7ERG]

Not sure just trying to see what parts work with minimun alteration.

I havent got any tuning parts yet.

Craig

[Anagonda]

Is the GT3071R hotside pure garrett T3... if so it will fit on this

http://cgi.ebay.co.uk/Kruemmer-Heade...QQcmdZViewItem

Thats the same manifold as on first post, but different flanges. As you can see on the weldings and bends.

And as I said in private message, if you buy a gt3076, or some else garrett you can get them with KKK housing from atpturbo.com , 034motorsport.com or Corey (034 seller in uk).

[s2dude]

Not sure just trying to see what parts work with minimun alteration.

I havent got any tuning parts yet.

Craig

As anagonda says...034 or Quattronics will supply a Garrett GT3071 ready to mount to a KKK flange. Normally this turbo is a T3 flange which is totally different.

The other alternative is to get a "good" engineering firm to cut off the KKK flange from a manifold and weld on a T3 one suitable for a garrett whcih leaves many options such as a T60-1 etc etc etc

[Faheemo]

Quote ebay"
DESCRIPTION:
This amazing Exhaust Manifold is made from 3 mm thick high grade stainless steel. "

It's a bargain if it really does have 3mm thick tubing for runners !!!