Has anyone got any pictures of the standard exhaust on the RS2 or S2 Avant from downpipe back showing the cat placement?
Thanks
Thanks
-
-
Not quite what you asked for but this as from my Milltek thread.
One of the standard cats go where the Milltek cat is and the other is on the left hand side of the transmission case.Cheers'en, AndyC
1994 ABY Coupe - Projekt Alpinweiss -
Can I bump an old post?
After what Jamo was, a good picture of the standard ABY Coupe/Avant cats in situ.
I'm trying to get my head around the fixing method of both in the centre of them.
Got two brand new cats (aftermarket, but direct fit) to go on and trying to plan ahead.
Ta muchly,
Jase..
2001 Avus Silver B5 RS4.
2004 A4 Avant 1.8T quattro Sport-LE.
1995 S2 Coupe - sold (sniff)Comment
-
Is this any help?
Just some finishing touches to do nowComment
-
Many thanks Lee, if only it was a bit further along. I'm trying to see how the two brackets on the cats fit to the underside of the car.
My car is miles away or I would venture out in the lashing gale outside and have a look.
Thanks for the response though mate, appreciated
2001 Avus Silver B5 RS4.
2004 A4 Avant 1.8T quattro Sport-LE.
1995 S2 Coupe - sold (sniff)Comment
-
I'm off work tomorrow and thursday so i'll try get some pics sorted for you.But i can't promise anything.Just some finishing touches to do nowComment
-
How's this?
cats RS2.jpgRob..
94 RS2 Noggy,LHD,MTM map,18"cup 1s,245/35/18,Bilsteins,RS2 H&Rs,Cup splitter.
87 UR 20v ABY
97 S6 Avant
96 A6 C4 2.5 TDI quattro avant,Ming,Wietec/eibach,chipped
1967 Ford Mustang,Eleanor,460ci v8Comment
-
That's what I was after! whoever built my current exhaust did not attach it to that point which means the whole exhaust weight is off the turboComment
-
Thanks again Lee, but it looks like Rob has come up with exactly the picture I was after.
Perfect Rob, that's the fella
Many many thanks mate
Oh, and my new cats are about the same size as those RS2 cats too, WAY smaller than the ABY ones.2001 Avus Silver B5 RS4.
2004 A4 Avant 1.8T quattro Sport-LE.
1995 S2 Coupe - sold (sniff)Comment
-
Rob,
Slight hijack, I'll keep it brief, is that low entry jack on the RHS of the photo any good?
TIA.Comment
-
Rob..
94 RS2 Noggy,LHD,MTM map,18"cup 1s,245/35/18,Bilsteins,RS2 H&Rs,Cup splitter.
87 UR 20v ABY
97 S6 Avant
96 A6 C4 2.5 TDI quattro avant,Ming,Wietec/eibach,chipped
1967 Ford Mustang,Eleanor,460ci v8Comment
-
Here is one more picture: RS2 exaust
Comment
-
I had the same problem after a replacement down pipe was fitted...restoring the front support (!!! - dont ask) restored a lot of shove..I have not checked the hot side, but am convinced that the full weight of the front exhaust could distort the rear turbo flange to no good effect....Comment
-
The bracket that the cats attach to is it separate and purchasable?Comment
-
AFAIK the bracket is integral part of the cats. You will need to fabricate some sort of bracket that leaves holes in the correct position for the spring / rubber assembly on a custom setup...
Cheers,
Steve.Last edited by Fat Audi 80; 4 March 2009, 15:45.The Perfectionist
sigpic
Audi Class Concours winner Stoner Park 2014, ADI Concours D'Elegance Class Winner 2008, Runner up 2014. Winner, S2Forum Show'n'Shine Billing 2006 & 2008.
Comment
Comment