Where can I get a (G42) Air Intake Temperature Sensor

[montez]

Does anyone know where I can get an AIT Sensor for the 3B? I have tried Audi and they are not showing any stock in the country so it could take up to a month to get one from them!!

Is there anyone else who stocks them in the UK or does anyone have an old one lying around which will solve my problem for a few weeks?

[2fast4you]

I think that you can use one fron the 1.8 T engine
http://www.034motorsport.com/product...roducts_id=117

[montez]

Can anyone confirm that this will work?

[epic]

I think the answer is no if you read the 034 description......

20v 1.8t Air Temp Sensor $35.00

Factory air temp sensor for the 20v 1.8t, very accurate, compatible with 034EFI systems, can be mounted in a .5" hole with o-ring seal, single 6mm mounting.

Can also be used on older Audi AAN/3B applications with the center hole slightly enlarged., but not electrically compatible with the factory Motronic engine management.

Takes standard 2-pin Bosch connector, available in the fueling components section: 2-pin Bosch Connector

[kirvis]

is it MAF you after?

[UrS4boy]

I *think* the issue is/was the original 3B intake air temperature sensor came pre-hardwired where as the later ones had a plug end. The current listing for the 3B air intake temperature sensor uses the later ABY sensor, 034905379B, but with a two pin connector housing 443906232 (you will also need two female pin connectors and will have to splice them into your harness).

I *think*.

Here is some more G42 IAT info that might be useful (or not):

http://forums.quattroworld.com/s4s6/msgs/20996.phtml