Wiring loom for Reverse Mount IM

[madpugger]

Paul was gonna maybe make extension looms

[Jamo]

You have to extend the throttle body and the ISV. Also check the MAT plug will reach

[madpugger]

Anyone had any joy with this yet?!

[mastermind]

I need the car for a track day event happing soon , so have decided to extend the wires for now. But I beleive lots of people will benefit from a plug in solution

[newsh]

Good point - does the ISV plug need to be extended as well ?

I'm not sure, maybe it will just reach as its not too far from its original location.

Edit; just been and had a look, it should reach no probs

[AndersS2]

Great work Paul!

The male's a pita to find, but you sourced it.

[S2central.net]

Good point - does the ISV plug need to be extended as well ?

[newsh]

Nice one Paul!

I'm doing the 3B so will need to extend and solder the IAT sensor anyway but a broken O2 sensor is a source of a 2 pin male with decent wire on it already.

We'll need to do the ISV too I guess, unless it will reach..

[madpugger]

Good effort Paul, I spent an hour or two on the Tyco website last night too

I will call Taylors tomorrow to try and get prices for the bits. I assume that they are Bosch Numbers?

[S2central.net]

Found it in the old Bosch paper catalog

6-pin MALE = 2 227 000 104 - there is a question whether supplied pins are perfect for this but lets see
6-pin FEMALE = 1 287 013 004
2-pin MALE = 1 287 013 002
2-pin FEMALE = 9 122 067 011

All above parts are supposedly kits that include pins and rubber boot. I'll try a couple of Bosch suppliers for prices - anyone else is welcome to try their local sources as well of course.

[S2central.net]

I have spent best part of an hour scouring the web for any type of 6-pin MALE JPT connector that is compatible with AMP/Tyco or Bosch.... Need to dig up the old Bosch catalog I found a while back.

[mastermind]

Great, thnx Paul,

If you are able to source the plugs I will definitely order a TPS extension and an Inlet Temp extension

[S2central.net]

I remember now... The 6pin male is odd as I only found bulkhead or pcb style connectors before now - like on the MAF or the TPS. Will keep looking.

[Acidburn]

Sounds like a group buys coming together

[newsh]

Part no for the femal MAF connector

"MAF uses 6-pin JPT connector, VAG part 022906233A for housing + 022906102B boot"