I'm building a 3" system for my 3B coupe and would like to know where i can get a 3" pipe bent to go over rear axle. I know there is'nt much room but no one in N.Ireland can do this for me any help on this would be great.
-
-
You can do it using off the shelf 45° bends such as this:-
http://cgi.ebay.co.uk/76-2mm-3-45-de...item3a646178b8
Not easy though, and requires a lot of trial and error, oh and the patience of a saint!!sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racer -
Have any any idea how many it takes
Comment
-
Just to get over the driveshaft? I would think 2 or 3. Is there anywhere near you that makes exhausts? I was lucky in that there is a place near me, and they let me rummage through the scrap parts to get what I needed
sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racerComment
-
Theres a powerfrow centre near me but i had them make me a standard replacement exhaust 4 or 5 years ago and they made a mess of bending over axle pipe all ripples so it looks like i'll have to make my own this shouldn't be a problem as i'm a welder by trade. thanks for your help.
Comment
-
If i rember Jetex do alot of 3" parts, hold on.... try here
hope it helps
ALComment
-
Bit expensive jetex, give pipewerx a call , I used to live down the road from them , very nice people , helpful and very good at what they do . They have an ebay shop but your better off ringing them and telling them what you want ,will prob be even cheaper than what is listed on the bay.
http://stores.ebay.co.uk/Pipe-Werx-P...4.l1513&_pgn=1
Comment
-
pipeline centre is spot on for 3" pipe, 90degree bends in stainless came to under £15 eachComment
Comment