Boost pipe to Intercooler connection

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Ian Simmonds
    S2Forum Fiend
    • Jun 2005
    • 2858
    • Country: United Kingdom

    #1

    Boost pipe to Intercooler connection

    On an ABY, there's the boost pipe that runs across the front, as it mounts onto the intercooler there's a silly little seal ring that sits between the two. I'm not 100% sure ours is sealing correctly and I'm going to 'revisit' the front end in a few days... Any suggestions on replacing/modifying this area to guarantee there isn't a leak?

    Kind regards

    Ian
    85 WR Urquattro, 85 20vT International liveried RallyRep
    93 MTMS2 Avant
  • Christophski
    S2Forum Possessed
    • Mar 2009
    • 3632
    • Country: United Kingdom

    #2
    Mark h mod! Basically it's a piece of hose that goes from one diameter to the next and you fit it over where the two join and obviously tighten with jubilee clips. I would send you the link but can't from my phone. Search mark h mod. There is loads of info on it on here. Just done mine btw.

    Comment

    • Ian Simmonds
      S2Forum Fiend
      • Jun 2005
      • 2858
      • Country: United Kingdom

      #3
      Originally posted by Christophski
      Mark h mod! Basically it's a piece of hose that goes from one diameter to the next and you fit it over where the two join and obviously tighten with jubilee clips. I would send you the link but can't from my phone. Search mark h mod. There is loads of info on it on here. Just done mine btw.
      Ah!

      So that's the Mark h mod!... I've often wondered, but never had the balls to ask.

      Righty-ho... Plan hatching...
      85 WR Urquattro, 85 20vT International liveried RallyRep
      93 MTMS2 Avant

      Comment

      • Christophski
        S2Forum Possessed
        • Mar 2009
        • 3632
        • Country: United Kingdom

        #4
        No worries bud. Always best to ask away

        Comment

        • Ian Simmonds
          S2Forum Fiend
          • Jun 2005
          • 2858
          • Country: United Kingdom

          #5
          Just ordered up a 70-60 reducer hose... Should be here for Monday next week (I'm off Monday and Tuesday)...

          VBR
          Ian
          85 WR Urquattro, 85 20vT International liveried RallyRep
          93 MTMS2 Avant

          Comment

          • Tony Stark
            S2Forum Addict
            • Nov 2009
            • 288
            • Country: United Kingdom

            #6
            I want to do this aswell mine has the original oring in it, gone hard as with age. Anyone know if a 70-60 hose will fit on a 3B i.c too?

            Thanks

            Comment

            Working...