3" Miltek clipping the rear driveshaft.

[andyg plym]

Heat shield on prop shaft btdt

[Ian Simmonds]

Heat shield on prop shaft btdt

Oh, go on then Andy, where abouts was it catching and how did you cure it.... Please....


Kind regards
Ian

[andyg plym]

The one that is under the end of the prop and joining the diff if you look at it you will think it looks fine but you physically need to pull it away from everything maybe the person who put the system on may if pressed up against it as they are so thin and easy to bend.

I found on mine the noise came when lifting off the throttle

[Christophski]

You mean when Ian put the system on lol... Hope that solves it bud

[Greg_S]

Mine catches on chassis at times above prop on the heat shield and sometimes the tailpipes clonk the back

[Ian Simmonds]

Well, sorted... Turns out it was the rear propshaft CV joint, nothing whatsoever to do with the exhaust...

[Christophski]

Haha glad you found it.