Can anyone please tell me how I can remove the side boot panels on my RS2?
RS2/S2 Avant side boot panel removal?
Collapse
X
-
Tags: None
-
i removed mine once by accident
was looking for strut top
from what i remember you have to remove the plastic trims that hold the seatbelt in place and also the boot floor hook (one for strapping down loads) then remove the peg that the seat clips into and it should pop off after that.
its not difficult but take your time and make sure you have everything off, why you need behind it? there isnt much in there
-
I want to mount a amp to one of themi removed mine once by accident
was looking for strut top
from what i remember you have to remove the plastic trims that hold the seatbelt in place and also the boot floor hook (one for strapping down loads) then remove the peg that the seat clips into and it should pop off after that.
its not difficult but take your time and make sure you have everything off, why you need behind it? there isnt much in there
1980 VW Golf GTI Track Car
1995 Audi RS2Comment
-
There is'nt much room behind them!
1]Remove the covers from the seatbelts, be very careful or they will snap!
2]Remove 2 bolts underneath them
3]Remove the post that the seat backs clip into
4]Remove the load fixing rings in the floor (they are ALL handed, be careful when refitting)
5]Remove the trim that goes across the roof and down the d-pilars
6]Undo the ends of the seatbelt to thread through the hole in the panel
7]Lift panel to removeLast edited by dest; 1 March 2010, 08:49.Comment
-
Dest is right with his guide.
The only thing you need to look out for is the edge by the windows has tabs that hock on the car body. So the trim needs to be lifted up to remove once all the other steps are done and rehooked on after when refitting or the trim will squeak.
Left side has most room.
I had an amp aprox 30cm x 25cm x 8cm mounted vertically behind the battery.
It was bonded on the corners with silicon to the car skin.
Worked fineLast edited by epic; 1 March 2010, 09:09.Comment
-
-
Is that how to get to the top mounts in the back of the avant? Haven't looked for em yet but know I gotta replace em over nxt few weeksComment
-
Comment
-
Avant has a different rear end from a coupe/b3Is that how to get to the top mounts in the back of the avant? Haven't looked for em yet but know I gotta replace em over nxt few weeks
Current-2004 Impreza PPP wagon
Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
Sold ABY-stockComment
-
Comment
-
-
Comment