Looking at getting a new alarm

[re2500]

Let me know how u get on, this is next weekends job for me, sounds like you may even get this done first.

[andy10v]

How did you get on with this?

[Rusty]

Very well. My only issues were some over-eager ultrasonic sensors but that was sorted with a screwdriver on the potentiometer and the setup menu through the LED was complicated by the fact that the LED flashed 1 time less than the stated value for some menus!!! Again, that was sorted by me trying lots of combinations and learning what was going on.

The immobiliser works well and cuts pretty much everything, including the ECU; it's all run along the factory looms, so 1001% better than a normal installation and all of the connections are soldered, heat shrunk etc. etc. at the fuse box.

Overall, it's a HUGE improvement over what was in there and the amount of boxes, wiring and scotchlocks that I removed would back that up!