RS2 driveshaft covers

[Tzummie]

hi, am searching for info on how the platic driveshaft covers should look like; These plastic arched covers are covered with foam; As the foam deteriorates over time, I need to refurbish them. But the width of the foam inside the arch is what I'm after. Anyone has info or photos?
IMG_20200920_201054.jpg IMG_20200920_201249.jpg
As you can see, mine are relatively intact, but one side is sticking out of the arch (see right photo), while at the other, the foam is as wide as the plastic arch. Can't tell if that's supposed to be different... Anyone?
thnx.

[Tractor Dave]

The one on the off side should have a foil heat reflective material on it. Apart from that, they look good.

[Tzummie]

thnx. yes, it does have that (one side). But my concern is the foam shape, one side sticking out (on the one with the heatshield tape).

the differences:
IMG_20200920_201249.jpg IMG_20200920_200757.jpg

[Tractor Dave]

I will see if I can find a pic to compare


Sent from my iPhone using Tapatalk

[Tractor Dave]

Post 182 in my 're build thread. You can just see it.

https://www.s2forum.com/forum/welcome-area/introductions/2009953-new-s2-avant-nothelle-n300-owner/page13

[Tzummie]

thnx, I see it, but need to see the inside.. :-)

[Tractor Dave]

thnx, I see it, but need to see the inside.. :-)

Audi Tradition have one for sale. Check the pic on there.