Feeler: Tubular Chromo wishbones

[squid]

I'd certainly be interested too. I have them on both my typ89 90 and my typ89 CQ. I have the AudiSport geometry and bearings though. As below.



I'd want just what you have there. I don't use the extra tab on the side of the arm though being for a typ89 chassis.

I know of someone else who makes these. Any idea on pricing? And I suppose shipping Stateside.

[MarkPS]

Hi

Any Idea of a price yet? would be intersted in a front pair for my 88(MB) 10v UR The 20v cast ones that I was thinking of upgrading to are apparently now NLA from Audi.

Regards
Mark

[jogi730]

Updates?
Cheers
Chris

[garym]

wishbones

if anyone is interested the wishbines and ali slider and topmount shown in squids post are made by me , the wishbones are t45 and they cost £210 each ,they are full wrc spec , people will probably make them cheaper but not better ,

[repo]

Have You tried these on yet? SPQ front wishbones won't fit to the URQ, that's for sure.

Lower balljoint more far to front in SPQ.

[rs2coupe]

Gary you have PM. anyone have his email I don't think he's been on in a while

[niall1]

Hi

The 20v cast ones that I was thinking of upgrading to are apparently now NLA from Audi.

Mark
Have you tried Pete Reeve @Quattro Corner. I got a set off him recently enough.
Niall

[Audi imsa racing]

Is it still possible to bye this wishbones? I was thinking of 2 sets (front and back) for my audi s2 3b.

[panzerwagen]

Where's Jeffer?

Has he deep sixed the chrome-moly wishbone project?

[Jeffer]

Hi peeps,

I'm busy as f*ck lately. But there's light at the end of the tunnel
No the wishbones haven't died. They are like uncut diamonds waiting to be tig welded.
Cheers!

[Albert]

I would be interested in full set for my S2.