Are there any UrS4 or UrS6 owners running this setup?

[Animal Mother]

I'm just about to get my bushes sorted and was going to get my springs done at the same time but don't want to buy the springs and find that my wheels don't fit.

235/40R18 tyres on Avus II wheels.
16mm Hubcentric spacers front and rear.
PLUS
Proposed H&R 30mm lowering springs

Tolerances are quite tight at the moment with the tyres just grazing the sticky out part of the mudflaps within the wheel arch.

If any of you have recently fitted H&R to an UrS4 or UrS6, what part number did you use? I'm looking at 29997-3.

Cheers

[K7ERG]

UFO's on the URS4 will be different to the S6.

Different brake setup and strut.

[Animal Mother]

UFO's on the URS4 will be different to the S6.

Different brake setup and strut.

Surely the S4 hub face will be in the same location as the S6 with reference to the wheel arch, as both the S4 and S6 were available with the same wheels with the same offsets?

[merlin's S4]

There is no difference between the two as far as suspension goes!

[lune]

My urs6 runs 255/35/18's 16mm spacers (32mm increase in track) with H&R/Koni combo & S8 (mk2) rims
No problems, just gentle over speed bumps & with full tank & a couple of adults in the back the wheels tuck under the arches without catching. Having said this it's that tight it looks as if I was on the lucky side