I am getting Koni adjustables fitted to my car in the next week or so. What else would you reccomend getting replaced while this is being done? Any bushes etc? Im not the best mechanically minded so i dont know what has to be removed when fitting konis.
-
3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips
(just need the RS2 Airbox) -
Topmounts, wishbone bushes and bottom ball joints if it needs them. The bumpstops and damper gaitors will probably be shot too.sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racer -
How much extra labour would it be to change all those bits?3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips (just need the RS2 Airbox)Comment
-
Apart from the ball joints, nothing as everything else has to come off anyway. Labour should be about 4/5 hours to do all four dampers, then at least another 2 hours to do the tracking and you should get this done again after 1k. To do both front bottom ball joints should take about 1.5 hours tops. HTH
Edit, I didn't notice wishbone bushes, to do both front wishbones with poly bushes should only take another hour or so whilst everythings apart, OME bushes will take a little longer as they have to pressed in, unless you buy new wishbones which will come with bushes installed.1990 B3 2.0 80 quattro.
1992 C4 2.8 Avant quattro
1994 MTM RS2.
1998 B5 TDI quattro Sport.
2000 B5 TQS.Comment
-
Oh and budget for a decent 4 wheel alignment after your suspensions been fitted'95 ABY Avant - Sold
'98 B5 S4 -MRC400+ = 464ps 741nmComment
Comment