S2 hub conversion

[bigcooler]

Does any one know if s2 hubs will fit a 1989 B3 audi 90 quattro as the wheels i want to get are the same stud pattern as the s2?

[Error404]

is it a 20v?

[bigcooler]

it did have the 10v kv engine but im putting an ABY in to it

[Error404]

in that case no as the CV splines are different. Also you will struggle to change the CVs as the driveshaft splines are different too IIRC.

Get hold of some CQ20v driveshafts and they will be plug and play as the gearbox flange PCD is the same on the KV and the 7A..... On the 7A the hub splines on the outer CV are the same as the S2.

I've got 2 front CQ20v driveshafts....

[bigcooler]

will the CQ20v rear shafts fit aswell, how much are you looking for them

[Error404]

yes they will IIRC. £20 each for the driveshafts

[bigcooler]

ok ill check my bank ballance and hopefuly buy them off you this week, where do you live as i might come pick them up off you rather than posting. one quick question what does IIRC mean

[Error404]

If-I-Remember-Correctly

I'm at Stone in Staffordshire, also going to ADI in a couple of weeks

[bigcooler]

thats audi driver international at castle combe?

[JMLAudi]

Driveshafts

Hi
i had to fit 20v driveshafts in front,and i used the Audi 90 orignal rear shafts on my Audi 90 quattro sport.....on my 5 stud flanges to 5 stud conversion

hope this helps
cheers
john

[bigcooler]

was yours the 90 with the kv engine too?

[JMLAudi]

HI

yes KV engine was in it ....i trying to do car up for a 3b conversion too at a later stage................its on 16 inch Auvs alloys at moment........check either my albums or john881000 i think i got pics of her there
otherwise i will post up later

cheers
john